How do I change the glass on Aduro P1?

Difficulty level: Easy
Time consumption: 15 minutes
Tools: Flexible bits screwdriver, TORX bits, Hex bits, PH bits, Flathead bits.
Materials: Gaskets 8x2 mm woven glassfiber

⚠ All changes and adjustments must be conducted when the stove is cold and disconnected from the
power supply.

Please handle the glass with care, as it can easily break. Damage caused by incorrect handling is not covered by Aduro. 

Replacing the inner glass

Open the door and locate the inner glass holder.

1. Remove the screws securing the glass frame (1).

2. Carefully remove the frame. Ensure the glass does not fall, as it is no longer secured (2).

3. Remove the glass (3).

4. Insert the new glass in the same position as the original. Ensure that all gaskets from the original installation are correctly reinstalled.

5. Refit the frame over the glass and tighten the screws.

It is important that the glass and frame are properly sealed, as smoke may leak if installed incorrectly. We recommend testing with a smoke stick to ensure there is no leakage.

Replacing the outer glass

Open the door and locate the glass holder profiles along the edges of the door.

1. Remove the screws holding the glass holder profiles (4).

2. From the front of the door, remove the outer profile on the side facing away from the stove. Loosen the opposite profile and move it aside as much as possible (5).

3. Tilt the glass slightly outwards and slide it to the right until it can be removed.

4. Insert the new glass into the holder profile in the same way as it was removed. Ensure the glass is correctly aligned and positioned.

5. Refit the holder profile over the glass.

6. Reinstall the screws in the holder profiles/door.