How do I install the external Wi-Fi module on my Aduro P1 and P4 pellet stove?

Difficulty level: Easy
Time consumption: 10 minutes
Components: External Wi-Fi module

Please note: All changes and adjustments must be conducted when the stove is cold and disconnected from the power supply.

On some of the Aduro P1 and P4 stoves, an internal Wi-Fi module is not fitted from the factory. Therefore, if control possibilities through the Aduro Pellet stove app are wanted, an external Wi-Fi module must be installed. Follow this guide to install the module:

1. Connect the Wi-Fi module to the stove, using the DB9 plug (see image 1 and 2).
2. The LED on the Wi-Fi module will flash orange and eventually turn solid blue, which indicates that the module is ready to connect to the Wi-Fi and app (see image 3).

Connect the Wi-Fi module to Wi-Fi

There are two ways to connect the module to the Wi-Fi:

• With an ethernet cable
• Via Wi-Fi

Follow one of the two methods in this guide to connect to your network.

General explanation of the external Wi-Fi module 

To restart the Wi-Fi module, turn off your stove on the main switch and turn it on again.

LED light description:

• Solid green: The device is connected to the Wi-Fi (either via ethernet or Wi-Fi).
• Solid blue: The device is ready to be connected to the Wi-Fi.
• Solid red: Error. The device should be factory reset.

Wi-Fi reset: 

If you want to connect to another Wi-Fi network, you must reset the Wi-Fi. Press and hold the Wi-Fi-reset button. The LED will flash pink. When it starts to flash orange, the Wi-Fi-reset is completed, and you may release the button. As soon as the LED is solid blue, the module is ready to be connected to another Wi-Fi network.

Factory reset: 

Press and hold the factory-reset button. The LED will flash red and eventually turn solid red. When it starts to flash orange, the factory-reset is completed, and you may release the button. As soon as the LED is solid blue, the module is ready to be connected.