How do I replace the control panel on my Aduro P1 or P4?

Difficulty level : Intermediate
Time consumption : 30 minutes
Tools : Bits screwdriver, TORX bits, Hex bits, Spanner set
Components : Control panel for Aduro P1/P4

⚠ All changes and adjustments must be conducted when the stove is cold and disconnected from the power supply.

Accessing the control panel

To access the control panel, the top plate must first be removed. Follow these steps:

1. Unscrew the two screws located underneath the front top cover to remove it (see picture 1).

2. Unscrew the screws at the back and remove both side panels.

3. From the underside of the top plate, 8 nuts need to be removed (see picture 2).

• Remove the 6 nuts securing the back flue pipe support (see picture 3).
• Remove the 2 nuts from the sides (see picture 4).

4. Carefully lift the top plate and turn it over. It is recommended to place it on a piece of cardboard on top of the stove to prevent damage.

Replacing the control panel

1. Unscrew the two screws securing the backplate of the control panel (see picture 5).

2. Disconnect the cable from the control panel (see picture 6).

3. Separate the components of the new control panel to prepare for installation (see picture 7).

4. Lift the top plate again, remove the remaining part of the old control panel, and replace it with the corresponding part from the new control panel.

5. Reattach the backplate to the back of the control panel, from the bottom side of the top plate, and mount the screws.

6. Reassemble the stove by following the steps in reverse order.

The installation is now complete.